 |
| Search: |
| | Shop Our Products: | | | 
| | |   | | Polyurethane Flo-Klear UFC35 by House of Kolor quart size | POLYURETHANE FLO-KLEAR may be used to topcoat any of our urethane or polyurethane enamels, or any of our SHIMRINŽ Base Coats. UFC35 gives an ultrahigh gloss finish with good abrasion resistance, is very flexible and polishes and buffs easily. Flo klear mixes 2 parts klear to 1 part Hardner (KU150) to 1 part RU reducer (RU310, RU311, RU312) and can be ordered below.
Can be ordered in quarts and gallons. APPLYING UFC35 FLO-KLEAR
First coat should be a medium wet coat with gun close. Apply 2-3 wet coats with 50% pattern overlap. Gun distance while spraying should be approximately 6 inches. Allow flash time between coats.
URETHANE FLASH TEST- PAINT SHOULD BE STICKY AND NOT STRING WHEN TOUCHED AT THE WETTEST POINT BEFORE NEXT COAT IS APPLIED. When using the flash test, always touch a new spot. Monitor closely for maximum merging of coats.
NOTE: Waiting too long between coats can cause re-coat problems. If excessive dry time has elapsed and clear coat feels dry to the touch, allow 24 hours before sanding and re-coating to avoid lifting problems.
NOTE: Over spray from any catalyzed topcoat material such as UFC35 may lift when basecoats are applied. Mask carefully to prevent this over spray when painting door jambs, etc. If basecoats are applied over UFC35, a 24-hour dry time at 70°F is required, then wet sand (PLEASE REFER TO SANDING GRIT RECOMMENDATIONS FOR URETHANE CLEARS). Use Fast Reducer, allow Flash between coats to prevent lifting.
House of Kolor FLO Clear product data sheet in pdf format
| | You May Also Like | | | Also In This Category | |
| |
